THE reference for power system transients

Cannot connect signals by name due to visibility issues.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 31 July 2025 at 13h48 #6850
    anonymous
    Keymaster

    Hi there,

    I am attempting to connect signals by name in my network but am getting this error/warning:

    I am aware that connecting signals by name is normally not recommended, but it is the best way for me to do it as I’m using a script to run 1000+ simulations.

    I have used this method previously with smaller networks with no issues, but for some reason it does not work with my newer, larger network.

    Any help would be appreciated.

    Thanks,

    Harrison

    31 July 2025 at 13h49 #6852
    anonymous
    Keymaster

    Hi,

    Which script functions are you using to connect the signals ?

    Best regards,

    Jerome Cornau

    31 July 2025 at 13h49 #6853
    anonymous
    Keymaster

    Hi Jerome, thanks for the response.

    I have attempted to use both ‘connectByName’ and ‘connectTo’ functions. In the past, the connectByName function has worked for me, however, in this new larger network, a lot of the output files show no response. If I then move the signals closer together, and re-simulate, I will get a non-zero output.

    The warning that I attached is displayed to me when I ‘zap’ the signals name. Also – I have the same issue as described above when I manually connect the signals by name.

     

    Thanks,

    Harrison

    31 July 2025 at 13h49 #6854
    anonymous
    Keymaster

    Could you send the model and the script to support@emtp.com ? We will investigate it.

    Best regards,

    Jerome Cornau

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.